Professional garage door hardware manufacturer in China for 13years    

 

Chi

Garage door remote control debugging process

by:Chi     2020-03-25
Step 1: clean code: purpose is to remove remote garage door open machine in all the remote control code before the match. Operation method: hold the door opener with code key and remain motionless, with light is lit, about 5 seconds later, with code lights put out automatically, the qing code successfully. In the process of buttons, pay attention to the hand can not loose or jitter, otherwise the code will go out, make people think the qing code completion. Step 2: with remote control code: with code: ready to need to match the remote control code, click on the door opener with code key, open the door machine code with the indicator is a normally on, press needs to match the buttons on the remote control code (at this time Remote control need to be away from the door machine antenna 1 meter above) , see code lights put out, the first remote control with code completion, loosen the remote control button; Then click the door opener with code key, open the door machine code with the indicator light into normally on, at this time hold down the need to match the second button on the remote control code, see code lights put out, the second with remote control code completion, loosen the remote control buttons. Note: such as before you did not press the remote control buttons, with light is extinguished, indicates the wrong door opener to other remote control code, show that the near other remote control operation. In this case, it is necessary to eliminate the interference sources, and starting from the qing code operation again. Note: in all the remote control with code is completed, check the door machine code indicating lamp, the state should be put out the lamp. Indicator, such as distribution yards with code is to open the door machine, likely match caused to the other remote control garage door to open the door or open the door to each other, should press the match code button at this time, make the code matching light is put out. Then open the door machine can begin to use normal.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...